I'm not getting into this one.
But, I will say, folks are just trying to help each other here, whether they're an "expert or not"...hey, it's a public forum, right? That' what input is all about! We usually get to a result sooner or later, and have some yuks along the way.
I'll post a little "primer" to maybe answer some questions and help y'all out.
PS...my guess LPS, is a bad diaphragm, or a needle stuck open from some poo, flooding things out.
It's helpful to understand what's going on and what part of the carb is being used at that time. Any one of several functions can affect operation in sometimes strange ways. What could sound like a rich low end needle setting could easily be a float setting on the needle & seat. A stiff diaphragm will make it run rich too. It could also make it run lean. The high end and low end needles interact throughout the entire throttle range. So if you adjust one needle, you will likely need to adjust the other slightly.
Understanding Fuel & Air Flow
Starting from the gas tank, fuel is pumped in through the carb inlet into a little diaphragm pump which is controlled by 2 one-way flapper valves. The fuel then passes through a needle & seat that is controlled by the float diaphragm. The float diaphragm manages how much fuel is available for the rest of the fuel circuit by opening & closing a passage utilizing a small lever attached to the needle. How much pressure it takes to move this needle off of its seat is called pop-off pressure. Less pressure means more fuel goes into the chamber and will enrichen the mixture. If it takes more pressure to pop off its seat then less fuel is available in the chamber ergo a leaner mixture.
Fuel in the float cavity area is waiting for a vacuum signal at the various jets. The lever setting is very critical since it controls the available fuel to the jets. If the lever is too low (or pop-off pressure too high), the engine will run lean, if the lever is too high (or pop-off pressure is too low), the engine will run very rich and will likely flood out at idle.
History: why so complex?
Float bowl carburetors were, for a long time, the standard method to deliver an engine's fuel and air. But they require being upright so gravity keeps the float floating and metering.
When designers started putting small gas engines on tools, they needed a way to work in unusual orientations. Viola, the membrane carb. You can hold it in any attitude and it will function.
All of these parts reside in the float cavity area as well as the fuel ready to be fed through the jets as needed. The amount of fuel available in the cavity is regulated by the lever and its relationship to the float diaphragm. So it's critical that the lever be set properly. Within the cavity, there are distribution holes that are managed by the low end and high end needles. Plus the idle circuit, which is a fixed size.
Another separate fuel circuit provides a small amount of fuel flow into the throat continuously which helps at the lowest throttle settings. At high power this circuit is still injecting fuel but represents a very small percentage of the total flow. This circuit helps keep a correct mixture for acceleration.
A few notes:
The low end needle is always the one closest to the engine, the high end needle is the closest one to the intake/choke.
On most carbs, both needs adjust the fuel flow but on a few, the low needle actually adjust the air inflow.
Carbs also have an idle stop screw which merely sets where the throttle stops. Screwing it in is just like slowly squeezing your throttle.
Both low end AND high end needles feed the top end fuel supply but the low screw affects the high end fuel flow much less.
Check Out Our Forum Tab!
Topic: Kicker motor won't start (Read 9066 times)
