Winchester SX-2 auto that wont eject low base.

[MN RACK ATTACK]

I can not get it to eject low base trap loads. It ocasionally will not eject 2-3/4" hi-base loads. Does anyone have any idea's?

[The General]

Have you ever taken the butt plate off and taken the spring out and cleaned all the gunk off of it?  I had the same problem with my Browning Gold.  Cabelas website has a step by step instructions and the toold needed to do this I'll try and find the website and post it here for you.

Here is the site.  Do this and you will see a major difference.  Also forget the crap oils like Rem-oil and the such go find yourself some Slip 2000 Gun Lube (probably have to get it from a gunsmith)http://www.cabelas.com/story-123/oseka_browning/10203/Deep%252Bcleaning%252Byour%252BBrowning%252BGold.shtml

[MN RACK ATTACK]

It sounds like its going to take a major clean on this one. Thanks for the info, very helpful. Not sure if im up to tackling this one, the gunsmith will probably it.

[The General]

I have done mine a few times.  If you follow the directions it's not hard at all you can definitely do this.